NCC
Law Source Retrieving System Laws And Regulations

Print Date：114/01/22 19:18

1. Scope
1.1 Accordance
The specification is issued pursuant to paragraph 1 of Article 42 of the Telecommunications Acts.
1.2 Application
This specifications applies to GSM and DCS mobile radio terminal within 900MHz band (TX from 890MHz to 915MHz and RX from 935MHz to 960MHz) and within 1800MHz band (TX from 1710MHz to 1785MHz and RX from 1805MHz to 1880MHz)。
1.3 Contents and Reference
The normative reference of the test items, conformance requirement, method of tests and relevant requirements for use in the specifications of GSM 900 and DCS1800 mobile radio terminals are based on the ETSI ETS 300 607-1 (GSM 11.10-1). These limits have been chosen to comply with the international standards for a complete technical regulation.

2. Abbreviations
2.1 Abbreviations

3. Required Test Items

4. Frequency Range
4.1 Test purpose
4.2 Conformance requirement
4.3 Method of measurement
4.3.1 Initial conditions
4.3.2 Procedure
4.4 Test requirement

5. Maximum Transmitter Output Power
5.1 Test purpose
5.2 Conformance requirement
5.3 Method of measurement
5.3.1 For equipment with a permanent antenna connector
5.3.2 For equipment with an integral antenna
5.4 Test requirement

6. Duplex Spacing
6.1 Test purpose
6.2 Conformance requirement
6.3 Method of measurement
6.3.1 Initial conditions
6.3.2 Procedure
6.4 Test requirement

7. Channel Spacing
7.1 Test purpose
7.2 Conformance requirement
7.3 Method of measurement
7.3.1 Initial conditions
7.3.2 Procedure
7.4 Test requirement

8. Spurious Emissions
8.1 Conducted spurious emissions
8.1.1 MS allocated a channel
8.1.2 MS allocated a channel
8.2 Radiated spurious emissions
8.2.1 MS in allocated a channel
8.2.2 MS in idle mode

9. Frequency Error
9.1 Frequency error due to modulation
9.1.1 Test purpose
9.1.2 Conformance requirement
9.1.3 Method of measurement
9.1.4 Test requirement
9.2 Frequency error under multipath and interference conditions
9.2.1 Test purpose
9.2.2 Conformance requirement
9.2.3 Method of measurement
9.2.4 Test requirement

10. Output RF spectrum
10.1 Test purpose
10.2 Conformance requirement
10.3 Method of measurement
10.3.1 Initial conditions
10.3.2 Procedure
10.4 Test requirement